Backup Server Error Messages 4.1.2 - 4.75.3
718
4.53.2 2 The load command specifies too many devices of type
`%1!': expected %2!, got %3!.
Explanation: Similar to 4.52.2; however, this is the
reverse case. Backup Server cannot load from more
stripes than were used for the original dump.
4.54.2 2 The load command specifies too few devices of type
`%1!': expected %2!, got %3!.
Explanation: At least one type of each device must
be specified in the load command
4.55.2 2 Device validation error: couldn't open raw d evice %1!,
error: %2!
Explanation: These errors denote failure to obtain
hardware characteristics after establishing the device
type. Check permissions on the device special file,
investigate the returned operating system error
message.
4.56.2 2 Device validation error: couldn't obtain tape drive
characteristics for device %1!, error: %2!
Explanation: These errors denote failure to obtain
hardware characteristics after establishing the device
type. Check permissions on the device special file,
investigate the returned operating system error
message.
4.57.2 2 Device validation error: couldn't obtain disk drive
characteristics for device %1!, error: %2!
Explanation: These errors denote failure to obtain
hardware characteristics after establishing the device
type. Check permissions on the device special file,
investigate the returned operating system error
message.
4.58.1 1 Database %1!: %2! kilobytes %3!ed.
Explanation: This message conveys the progress of
the dump or load session. %3 is “DUMP” or “LOAD”.
4.59.3 3 Archive device %1! must either be a STRIPE or
MIRROR.
Explanation: Internal error, contact Sybase
Technical Support. This error can occur only if
Adaptive Server incorrectly translated a dump
command.
Number Severity Text and Explanation