When you run the TalkSwitch software, you will need to select ‘PC Connection’ to select Serial as the connection then select the COM port associated to this physical Serial port on your PC.

Make sure you do not have any other communications programs running at the same time you want to use the TalkSwitch configuration software. These may include Palm Pilot, Hot Sync, TalkWorks, Digital Camera software. These programs tend to ‘hold’ onto COM ports and not make them available for any other programs.

If you are having problems communicating with TalkSwitch, please check the Troubleshooting section of the manual.

1.4.4.2 Connecting TalkSwitch to a PC using a USB cable

If you have an available USB port and cable and are not running Windows 2000 or XP on your PC, then connect TalkSwitch to the PC using the USB cable*. Next, pick

up a phone connected to one of TalkSwitch’s local extensions and dial to enter command mode. If you have an administrator password enabled, enter the password.

Dial 91then to activate the USB connection. Next, turn TalkSwitch off then back on again to activate the USB drivers.

Make sure you do not have any other communications programs running at the same time you want to use the TalkSwitch configuration software. These may include Palm Pilot, Hot Sync, TalkWorks, Digital Camera software. These programs tend to ‘hold’ onto COM ports and not make them available for any other programs.

* USB cable not provided.

1.0

Installing TalkSwitch

9

Page 14
Image 14
Talkswitch 48 user manual Connecting TalkSwitch to a PC using a USB cable