Grey Headline (continued)
Zones
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
Configuring Traversal Client Zones
Authentication username
Traversal clients must always authenticate with traversal servers by providing their authentication username and password.
The client’s authentication username is shown here for reference, to make it easier to configure the corresponding zone on the traversal server.
The authentication username is a
H.323 mode
Determines whether H.323 calls will be allowed to and from the traversal server.
H.323 protocol
Determines which of the two firewall traversal protocols (Assent or H.460.18) to use for calls to the traversal server. (See Firewall Traversal Protocols for more information.)
H.323 port
Specifies the port on the traversal server to be used for H.323 calls to and from the local VCS.
For firewall traversal to work via H.323,
the traversal server must have a
traversal server zone configured on it to represent this VCS, using this same port number.
For full details on how traversal client zones and traversal server zones work
together to achieve firewall traversal, see Firewall Traversal.
Introduction | Getting Started |
| Overview and |
| System |
| VCS | Zones and | Call |
| Bandwidth | Firewall |
| Status |
| Configuration |
| Configuration | Neighbors | Processing |
| Control | Traversal | ||
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
|
| 86 |
|
|
| |
MAY 2008 |
|
|
|
|
|
|
|
|
|
| ||
SIP mode
Determines whether SIP calls will be allowed to and from this zone.
SIP port
Specifies the port on the traversal server to be used for SIP calls to and from the VCS.
SIP transport
Determines which transport type will be used for SIP calls to and from the traversal server.
For firewall traversal to work via SIP, the
traversal server must have a traversal
server zone configured on it to represent this VCS, using this same transport type and port number.
Retry interval
Specifies the interval in seconds with which a failed attempt to establish a connection to the traversal server should be retried.
Primary address
Specifies the IP address or FQDN of the traversal server.
Alternate 1 to Alternate 5 address
Specifies the IP addresses or FQDNs of any alternates configured on the traversal server.
