Grey Headline (continued)
Command Reference - xCommand
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
RouteAdd
Adds and configures a new route.
Address(r): <S: 1, 39>
Specifies an IP Address used in conjunction with the Prefix Length to determine the network to which this route applies.
PrefixLength(r): <1..128>
Specifies the number of bits of the IP Address which must match when determining the network to which this route applies.
Gateway(r): <S: 1, 39>
Specifies the IP Address of the Gateway for this route.
Interface: <Auto/LAN1/LAN2>
Specifies the LAN interface to use for this route. Auto: The VCS will select the most appropriate interface to use. Default: Auto
Example: xCommand RouteAdd Address: "10.13.8.0" PrefixLength: 32 Gateway: "192.44.0.1"
SubZoneAdd
Adds and configures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP Address to belong in this subzone.
TotalMode: <Unlimited/Limited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
PerCallInterMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited).
PerCallIntraMode: <Unlimited/Limited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if Mode is set to Limited).
Example: xCommand SubZoneAdd SubZoneName: "BranchOffice" Address: "10.13.0.0" PrefixLength: 28 TotalMode: Limited Total: 1024 PerCallInterMode:
Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512
Introduction | Getting Started |
| Overview and |
| System |
| VCS |
| Zones and |
| Call |
| Bandwidth |
| Firewall |
| Maintenance | Appendices |
| Status |
| Configuration |
| Configuration |
| Neighbors |
| Processing |
| Control |
| Traversal |
| ||||
|
|
|
|
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
|
|
| 223 |
|
|
|
|
|
|
| ||
MAY 2008 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
