Grey Headline (continued)
IP
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
Overview |
| IP Configuration |
|
|
|
To configure the VCS’s IP settings:
•System Configuration > IP.
You will be taken to the IP page.
•xConfiguration IP
•xConfiguration IPProtocol
About IPv4 to IPv6 Gatewaying
The VCS can act as a gateway between IPv4 and IPv6 calls. To enable this feature, select an IP Protocol of Both.
Some endpoints support both IPv4 and
IPv6, however an endpoint can use only
one protocol when registering with the VCS. Which protocol it uses will be determined by the format used to specify the IP address of the VCS on the endpoint. Once the endpoint has registered using one protocol, calls to it from an endpoint using the other protocol will be gatewayed by the VCS.
About IP Routes
The options on this page allow you to set the default IPv4 and IPv6 gateways used by the VCS. This is the gateway to which IP requests are sent for IP addresses that do not fall within the VCS’s local subnet. However, you can also
IP protocol
You can configure the VCS to use IPv4, IPv6 or Both protocols. The default is Both.
IPv4: The VCS will only accept registrations from endpoints using an IPv4 address, and will only take calls between two endpoints communicating via IPv4. It will communicate with other systems via IPv4 only.
IPv6: The VCS will only accept registrations from endpoints using an IPv6 address, and will only take calls between two endpoints communicating via IPv6. It will communicate with other systems via IPv6 only.
Both: The VCS will accept registrations from endpoints using either an IPv4 or IPv6 address, and will take calls using either protocol. If a call is between an
IPv4 gateway
Specifies the default IPv4 gateway of the VCS.
IPv6 gateway
Specifies the default IPv6 gateway of the VCS.
configure additional IP routing information
on the VCS. This is sometimes required when using the Dual Network Interfaces option and occasionally required in other complex network deployments. You can configure routes for up to 10 networks and host combinations.
IP routes are configured via the CLI only using:
•xConfiguration IP Route
•xCommand RouteAdd
The VCS cannot act as an IPv4 to IPv6 |
| Calls for which the VCS is acting as an |
gateway at the same time as it is acting |
| IPv4 to IPv6 gateway are traversal calls. |
as a SIP to H.323 gateway. |
| They will therefore require a traversal |
|
| call licence. |
|
|
|
Restart
Click here to restart the system.
Save
Click here to save your changes.
You must
save your changes and
restart the system for changes to take effect.
Introduction | Getting Started |
| Overview and | System | VCS |
| Zones and |
| Call |
| Bandwidth |
| Firewall |
| Maintenance |
| Appendices |
| Status | Configuration | Configuration |
| Neighbors |
| Processing |
| Control |
| Traversal |
|
| ||||
|
|
|
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
| 50 |
|
|
|
|
|
|
|
| ||
MAY 2008 |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
