Grey Headline (continued)
Configuring the VCS as a Traversal Client
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
Configuring a Traversal Client Zone
•VCS Configuration > Zones.
You will be taken to the Zones page. Click on the name of the zone you wish to configure.
You will be taken to the Edit Zone page.
• xConfiguration Zones Zone [1..200]
•xConfiguration Zones Zone [1..200] Traversal Client
Hop count
Specifies the hop count to be used when querying this zone.
Authentication username
This field displays the Authentication username that has been configured on this VCS. The Authentication username and password are
is needed when configuring the corresponding Traversal Server Zone.
To edit the Authentication username, click on the Edit Authentication Username/Password link. This will take you to the Authentication page, where you can edit the settings under the External Registration Credentials section.
Primary address
Specifies the IP address or FQDN of the traversal server.
Alternate 1..5 Address
Specifies the IP addresses or FQDNs of any alternates configured on the traversal server.
Introduction | Getting Started |
| Overview and |
| System |
| VCS |
| Zones and |
| Call |
| Bandwidth | Firewall |
| Status |
| Configuration |
| Configuration |
| Neighbors |
| Processing |
| Control | Traversal | ||
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
|
|
| 153 |
|
|
| ||
MAY 2008 |
|
|
|
|
|
|
|
|
|
|
| |||
SIP mode
Determines whether SIP calls will be allowed to and from this zone.
SIP port
Specifies the port on the traversal server to be used for SIP calls from this VCS.
SIP transport
Determines which transport type will be used for SIP calls to and from the traversal server.
H.323 mode
Determines whether H.323 calls will be allowed to and from this zone.
H.323 protocol
Determines which of the two firewall traversal protocols to use for calls to the traversal server.
H.323 port
Specifies the port on the traversal server to be used for H.323 firewall traversal calls.
Retry interval
Specifies the interval in seconds with which a failed attempt to establish a connection to the traversal server should be retried.
Remember to Save your changes.
