Grey Headline (continued)
SNMP
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
Overview |
| Configuration |
|
|
|
To configure the VCS’s SNMP settings:
•System Configuration > SNMP
You will be taken to the SNMP page.
•xConfiguration SNMP
About SNMP
Tools such as TANDBERG Management Suite (TMS) or HP OpenView may act as SNMP Network Management Systems (NMS). They allow you to monitor your network devices, including the VCS, for conditions that might require administrative attention.
The VCS offers basic support for SNMP, and supports Version 1 and Version 2c of the SNMP protocol. The information provided by the VCS is defined by SNMP
•system uptime
•system name
•location
•contact.
To allow the VCS to be monitored by an SNMP NMS, you must enable SNMP on the VCS and provide the name of the SNMP community within which it resides. You may optionally provide the name of a System contact and the physical Location of the system for reference by administrators when following up on queries.
By default, SNMP is Enabled with a SNMP community name of public.
Note: the VCS does not support SNMP traps or SNMP sets, therefore it cannot be managed via SNMP.
Enabled
Select On to enable SNMP support.
You must save your changes and restart the system for any changes to take effect.
SNMP community name
Sets the VCS’s SNMP community name.
System contact
Specifies the name of the person who can be contacted regarding issues with the VCS.
Location
Specifies the physical location of the VCS.
Restart
Click here to restart the system.
Save
Click here to save your changes.
Introduction | Getting Started |
| Overview and | System | VCS |
| Zones and |
| Call |
| Bandwidth |
| Firewall |
| Maintenance |
| Appendices |
| Status | Configuration | Configuration |
| Neighbors |
| Processing |
| Control |
| Traversal |
|
| ||||
|
|
|
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
| 54 |
|
|
|
|
|
|
|
| ||
MAY 2008 |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
