Grey Headline (continued)
CommandHeadline TextReferenceGoes Here- xConfiguration
TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE
Zones Zone [1..200] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the Traversal Server zone for this VCS.
Default: 2777
Example: xConfiguration Zones Zone 2 TraversalClient H323 Port: 2777
Zones Zone [1..200] TraversalClient H323 Protocol: <Assent/H46018>
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example: xConfiguration Zones Zone 2 TraversalClient H323 Protocol: Assent
Zones Zone [1..200] TraversalClient Primary Address: <S: 0, 128>
Specifies the IP Address or Fully Qualified Domain Name (FQDN) of the traversal server.
Example: xConfiguration Zones Zone 2 TraversalClient Primary Address: "10.192.168.1"
Zones Zone [1..200] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server should be retried.
Default: 120
Example: xConfiguration Zones Zone 2 TraversalClient RetryInterval: 120
Zones Zone [1..200] TraversalClient SIP Port: <1024..65534>
Specifies the port on the traversal server to be used for SIP calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the Traversal Server zone for this VCS.
Default: 5060
Example: xConfiguration Zones Zone 2 TraversalClient SIP Port: 5060
Zones Zone [1..200] TraversalClient SIP Transport: <TCP/TLS>
Determines which transport type will be used for SIP calls to and from the traversal server.
Default: TCP
Example: xConfiguration Zones Zone 2 TraversalClient SIP Transport: TCP
Zones Zone [1..200] TraversalServer Authentication UserName: <S: 1, 128>
The name used by the traversal client when authenticating with the traversal server. If the traversal client is a VCS, this must be the VCS’s Authentication User Name. If the traversal client is a gatekeeper, this must be the gatekeeper’s System Name.
Example: xConfiguration Zones Zone 3 TraversalServer Authentication UserName: "User123"
Introduction | Getting Started |
| Overview and |
| System |
| VCS |
| Zones and |
| Call |
| Bandwidth |
| Firewall |
| Maintenance | Appendices |
| Status |
| Configuration |
| Configuration |
| Neighbors |
| Processing |
| Control |
| Traversal |
| ||||
|
|
|
|
|
|
|
|
|
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
D14049.03 |
|
|
|
|
|
|
|
| 212 |
|
|
|
|
|
|
| ||
MAY 2008 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
