8-10

Using the UP/DOWN Arrows

To increase the level, click on the up arrow. To decrease the level attenuation, click on the down arrow. The amount of increase or decrease is controlled by the fine/coarse control.

Fine (F) or Coarse (C) Control

This button determines the increment/decrement associated with the UP/DOWN arrows. Fine produces small steps in value, while Coarse provides large steps in value. Clicking on the button will toggle the setting.

Knee Control

This button determines the type of transition that occurs when the component goes from inactive to active. A Hard knee causes the response by the component to be abrupt, while a Soft knee causes a gentle response. Clicking on the button will toggle the setting.

Ratio Control

To change settings, click on the arrow next to the number in the text box. A selection list will appear. The list may or may not be scrollable. To make a selection click on the desired entry.

Sidechain

To make a selection click on the desired entry.

Bypass Control (master)

This button determines if the component is in the processing chain. If the LED on the button is gray, then the component is inserted into the signal processing chain. If the LED is red, then the component is bypassed in the signal processing chain. A bypassed component will be colored red in the QuickMAP.

10 July 1998

Page 80
Image 80
Telex ISP-100 manual Knee Control, Ratio Control, Sidechain