Texas Instruments TMS380C26 specifications 80x8x mode bus release timing, Sbrls Sown, TW or, 208c

TMS380C26

NETWORK COMMPROCESSOR

SPWS010A±APRIL 1992±REVISED MARCH 1993

PARAMETER MEASUREMENT INFORMATION

80x8x mode bus release timing

NO.

PARAMETER

MIN MAX

UNIT

208a

Setup of asynchronous input

low before SBCLK no longer high to guarantee recognition

15

ns

SBRLS

208b

Hold of asynchronous input

low after SBCLK low to guarantee recognition

15

ns

SBRLS

208c

Hold of

low after

high

0

ns

SBRLS

SOWN

T(W or 2)

T3

T4

T1

T2

SBCLK

208a

SBRLS (see Note A)

208b

SOWN

208c

NOTES: A. The System Interface ignores the assertion of SBRLS if it does not own the system bus. If it does own the bus, then when it detects the assertion of SBRLS, it will complete any internally started DMA cycle and relinquish control of the bus. If no DMA transfer has internally started, then the System Interface will release the bus before starting another.

B.If SBERR is asserted when the System Interface controls the system bus, then the current bus transfer is completed, regardless of the value of SRDY. If the BERETRY register is non-zero, the cycle will be retried. If the BERETRY register is zero, the System Interface will then release control of the system bus. The System Interface ignores the assertion of SBERR if it is not performing a DMA bus cycle on the system bus. When SBERR is properly asserted and BERETRY is zero, however, the System Interface releases the bus upon completion of the current bus transfer and halts all further DMA on the system side. The error is synchronized to the local bus and DMA stops on the local sides. The value of the SDMAADR, SDMADDRX, and SDMALEN registers in the System Interface are not defined after a system bus error.

C.In cycle-steal mode, state TX is present on every system bus transfer. In burst mode, state TX is present on the first bus transfer and whenever the increment of the DMA Address Register carries beyond the least significant 16 bits.

D.SDTACK is not sampled to verify that it is deasserted.

E.Unless otherwise specified, for all signals specified as a maximum delay from the end of an SBCLK transition to the signal valid, the signal is also specified to hold its previous value (including high-impedance) until the start of that SBCLK transition.

Figure 36. 80x8x Mode Bus Release Timing

74	POST OFFICE BOX 1443 •HOUSTON, TEXAS
	77251±1443