Thermador PRD48 Range Cleaning, To Set Self-Clean At the End of the Clean Cycle, Cleaning Hints

Models: PRD30 PRD36 PRD48

1 106
Download 106 pages 60.11 Kb
Page 42
Image 42
To Set Self-Clean

To Set Self-Clean

At the End of the Clean Cycle

Cleaning Hints

Make certain that the oven door is locked at the beginning of the self-cleaning cycle.

1.Select SPEED CLEAN using the Selector switch.

2.Set Oven Control Knob to SPEED CLEAN.

Cooling Blower turns on.

PREHEATING, HEATING, and CLEANING lights and turn on.

The door closing process takes approximately 60 seconds to complete, at which time the door becomes locked. Check to make certain the door is locked.

Figure 23: 30” Oven Control Knob

The Clean cycle takes 2 hours to complete. The blower and the HEATING light and the CLEANING light turn off when the cycle is finished. Do not turn the selector switch or the oven control knob to the OFF position until the automatic lock cycles to the open position.

1.Select OFF using the Selector Switch.

The door latch will open automatically when the oven is below 500°F and the automatic Door Lock completes its 60 second cycle to the open position.

The cooling blower turns off when the oven temperature drops to 325°F.

2.Turn Oven Control Knob to OFF position.

1.The porcelain enamel finish is acid resistant, but not acid proof. Acidic foods, such as citrus juices, tomatoes, rhubarb, vinegar, alcohol or milk, should be wiped up and not allowed to bake onto the porcelain during the next use.

2.Remove the oven racks. See Racks, on Range Cleaning Recommendations, Page 39.

3.The heating elements in the oven do not require cleaning; the elements burn themselves clean when the oven is in use. Both elements are permanently connected. It is not necessary to clean the broiler shield above the broil ele- ment.

CAUTION

The interior of the oven will still be at baking temperatures when the automatic lock cycles to its open position and the oven door can be opened.

Range Cleaning

When Cleaning This Range:

1.Use the mildest cleaning procedure that will do the job efficiently and effectively. Some cleaners of the same type are harsher than others. Try on a small area first.

2.Always rub metal finishes in the direction of the polish lines for maximum effec- tiveness and to avoid marring the surface.

Page 39

Page 42
Image 42
Thermador PRD48 Range Cleaning, To Set Self-Clean At the End of the Clean Cycle, Cleaning Hints, When Cleaning This Range