3.2 Executing the Diagnostic Test | 3 Tests and Diagnostics |
Select the option you want to execute and press Enter. When you select 1- SYSTEM TEST, the following message will appear:
SYSTEM TEST NAME | XXXXXX |
xxxxxxxDIAGNOSTIC TEST VX.XX [Ctrl]+[Break] : test end
[Ctrl]+[C] | : key stop |
| : XX | ERROR COUNT | : XXXXX | |||
PASS | COUNT | : XXXXX | ||||
WRITE DATA | : XX | READ DATA | : XX | |||
ADDRESS |
| : XXXXXX STATUS | : XXX | |||
MENU : |
|
| ||||
01 | - | ROM | checksum |
|
| |
04 | – | Fan | ON/OFF |
|
| |
05 | - | Geyserville |
|
| ||
06 | - | Quick | charge |
|
| |
07 | – | DMI | read |
|
| |
99 | - | Exit to DIAGNOSTIC TEST MENU |
|
NOTE: The menu displayed by your computer may be slightly different from the one shown above.
Select the desired subtest number from the subtest menu and press Enter. The following message will appear:
TEST LOOP : YES (or NO)
ERROR STOP : YES (or NO)
Use the right and left arrow keys to move the cursor to the desired option.
Selecting YES of TEST LOOP increases the pass counter by one, each time the test cycle ends and restarts the test cycle.
Selecting NO returns the process to the subtest menu after the test is complete. Use the up and down arrow keys to move the cursor to “ERROR STOP”.
Use the right and left arrow keys to move the cursor to the desired option and press Enter.
PORTEGE R500 Maintenance Manual | [CONFIDENTIAL] |