4 Replacement Procedures

4.20 Display portion

To install the display portion, follow the steps below and refer to Figure 4-30 to 4-32.

1.Set the power switch holder to the slot.

2.Set the sensor board to the application button holder and connect the sensor cable to the connector on the sensor board.

3.Set the application button holder to the slot.

4.Set the display portion to the middle frame.

CAUTION: An insulator is not put on the back of a new middle frame. Stick a new insulator as shown in the figure below.

Insulator

4-52

[CONFIDENTIAL]

PORTÉGÉ R500 Maintenance Manual (960-634)

Page 268
Image 268
Toshiba r500 manual Replacement Procedures Display portion