2 Troubleshooting Procedures

2.14 Wireless LAN Troubleshooting

Procedure 3 Antenna Check

Check 1 Use an antenna test cable to check the antennas' connection. Follow the steps below:

1.Remove the wireless LAN slot cover and lift it off. Refer to Chapter 4, Replacement Procedures, for detailed steps of disassembling.

2.Disconnect the wireless LAN antenna cables connected to the wireless LAN board.

3.Connect the end of the antenna test cable to the multimeter.

4.Connect the Main antenna cable to the antenna test cable. One clip is connected to the end of the antenna cable. The other is connected to the opposite side of the antenna cable.

5.Determine the resistance. The cable passes the test when the resistance is less than 5 ohm. If it is more than 5 ohm, the Bluetooth antenna cable fails the test.

6.Change the antenna cable. Perform from step 3 to check the black antenna cable.

Figure 2-4 Antenna Test cable

NOTE: 1. The resistances determined with the steps above may not be stable with other machines because of "cable loss," which varies according to the length of the cable. The impedance of the antenna itself is about 0.5-0.8 ohm.

2.The above steps cannot accurately determine the impedance of the antenna. Use an LC meter for a precise measure of impedance.

If the wireless LAN antenna cables pass the test, connect them to the wireless LAN board and cover the slot, then perform Procedure 1.

If the wireless LAN antenna cables do not pass the test, replace the wireless LAN antenna cables with new ones following the steps in Chapter 4, Replacement Procedures. If the wireless LAN is still not functioning properly, go to Procedure 4.

2-56

TECRA M1 Maintenance Manual (960-436)

Page 112
Image 112
Toshiba tecra m1 manual Procedure 3 Antenna Check