4.25 Fluorescent Lamp | 4 Replacement Procedures |
8.Tighten the four screws (E) on the sides. Make sure the two latches are precisely mated.
Figure 4-69 Replacing Sharp fluorescent lamp (SXGA+) (8)
9.Install the protection cover S (A), protection cover G (B), aluminum tape (C) and fixing tape for lead wire (D). Use new parts.
•Stick the protection covers in the order of (B), (A) to the standard line for fitting pin.
•Stick the aluminum tape (C) following the sticking standards.
Long sides: Stick to the
Short sides: Stick to the edge of lamp cover.
•Stick the fixing wire for lead wire following the sticking standards. Long sides: Stick to the outline of the LCD module.
Short sides: Stick so that the wire covers the screws.
TECRA M1 Maintenance Manual |
