154 | System Configuration Setup |
|
SCSI Utility |
| |
| c Host Adapter SCSI Termination | : Enabled |
Specifies whether the SCSI bus is to be terminated using the SCSI host adapter. Do not change this setting.
cBoot Device OptionsSpecifies the SCSI device from which the system is to be booted.
c Boot SCSI ID | : 0 |
Selects the SCSI ID of the device which boots the system. Do not change this setting.
c Boot LUN Number | : 0 |
Selects the LUN of the device which boots the system. Do not change this setting.
cSCSI Device ConfigurationSpecifies detailed configuration information for each SCSI device (SCSI ID).
c Sync Transfer Rate (MB/Sec) | : 160 |
Specifies the maximum synchronous transfer rate of the onboard SCSI controller.
c Initiate Wide Negotiation | : Yes |
Set this item to Yes to specify Wide SCSI (16 bit data width).
c Enable Disconnection | : Yes |
Set this item to Yes to make the adapter activate the disconnect/ reconnect function and permit
c Send Start Unit Command | : Yes |
Specifies whether a start unit command is to be sent from the adapter to start the SCSI device.
c Enable | : N/C |
Specifies whether to use the
c BIOS Multiple LUN Support | : No |