Toshiba Z300 Starting up by the hard disk drive unit (in the case the OS has been installed)

36	Getting Started
	Starting up the system

Starting up by the hard disk drive unit (in the case the OS has been installed)

To start up the server from the hard disk drive unit, proceed as follows:

1Make sure that neither the floppy disk nor CD-ROM that is capable of starting up the server is in either drive unit.

2Switch on the power/sleep button.

NOTE: The CD-ROM can be ejected from the CD-ROM drive unit only when the system is on. Always remove the CD- ROM from its drive unit before turning the system off.

If you are in doubt as to whether a CD-ROM is set in the CD- ROM drive unit, check by pressing the eject button of the CD- ROM drive unit. This procedure must be done while the power-on self test is being performed once the power/sleep button is turned on.

If the start up CD-ROM is placed in the CD-ROM drive unit, the startup operation from the hard disk drive unit will result in failure, even if the CD-ROM is ejected once the system is has been switched on.