System Configuration Setup | 167 |
Configuring MegaRAID IDE |
DRIVE SELECTION BOX
[ | ] Cntlr |
[ | ] Cntlr |
Use the arrow navigation keys and press the Spacebar to select or deselect the drive or drives to be part of the array. Press <Enter> when done. If you select mirror mode as the array type, you must select two drives to be in the array. This
Stripe size field applies to stripe mode arrays only. By default, an array is set up with 64 KB stripes. Edit this field to change the default stripe size. The options for the size of the Stripes are listed in the table below.
STRIPE
32KB
64KB
128KB
256KB
512KB
1024 KB
2048 KB
4096 KB
NOTE: You cannot change the stripe size of an array that has already been configured.