233

7Remove the sever panels, power supply unit and board for wireless card, and return the jumper switch to 3-4 short.

8Install the board for wireless card, the power supply unit and server panels.

9Connect the AC power cable again and restart your server.

10Start the BIOS Setup Utility, set System Time and System Date and select “Load Setup Default” from the Exit menu to execute it.

NOTE: The standard settings displayed after the original data has been cleared are the initial data of the motherboard, and they may differ from the defaults (recommended settings).

When the original data is cleared, password of the security menu and data settings of the SCSI controller will also be cleared.

Before clearing information, remove all expansion cards.

Recovery Boot

Perform the following operations if the recovery boot is needed:

1Disconnect AC power cable.

2Remove the server panles, power supply unit and board for wireless card.

3Set the jumper switch PJ723 on the motherboard of the server to 2-3 short.

PJ723: 2-3 short ... Recovery Boot. 1-2 short... Normal Boot

4Install the board for wireless card, power supply unit and server panels, and connect the AC power cable.

5Insert BIOS Recovery Diskette into floppy disk drive and turn on the server. The recovery process will take a few minutes.