Installing Software | 193 |
AFT, ALB and IPSec functions |
1Start up “Intel(R)PROSet II” from “Start” - “Settings” - “Con- trol panel”.
2Select one LAN adapter to configure AFT/ALB on from the “Intel(R)PROSet II” adapter list, click the right mouse button, and select “Create New Team” under “Add Team”.
3The Teaming Wizard screen is displayed. Select either “Adapter Fault Tolerance” or “Adaptive Load Balancing”, and click “Next”.
4Mark the checkbox of the LAN adapter to add to the configu- ration, and click “Next”.
5Click “Done”.
6The “member Adapters” icon is displayed in the PROSet II screen. Among the cards on which AFT/ALB is installed select a card to set as the primary, click the right mouse button, and click “Preferred Primary”.
7Click any one of the remaining cards in the PROSet II screen with the right mouse button, and click “Preferred Secondary”.
NOTE: All cards other than the card that you selected as
“Preferred Primary” are treated as if “Preferred Secondary” has been selected. However, select “Preferred Secondary” preferentially for a specific card from among these cards.
8Click “OK”.
9The network settings screen is displayed for the team that has been created. Set the IP address and other network settings for that team.
10Restart the server.
Setting IPSEC (installing Packet Protect)Set as follows to use IPSEC functions.
1Make sure that the following conditions are satisfied: