178

Installing Software

NetWare

6Install the Service and Software (Power Console Plus) of the RAID Controller (when the RAID Controller is additionally connected) or MegaRAID Configuration Console (when IDE RAID is used).

7Install the Backplane Driver (when IDE RAID is used).

Use the floppy disk supplied with the RAID Controller for installation.

See “MegaRAID Software Guide” for details of installation.

NetWareBefore installing the NetWare

If the Toshiba Server Setup Tool is used, it automatically carries out setup of the system configuration and RAID (disk array) as well as installation of the MS-DOS. In other words, the Toshiba Server Setup Tool automatically prepares the installing environment for the NetWare.

On the other hand, an MS-DOS disk can be created by use of the Toshiba Server Setup Tool so that the MS-DOS environment can be set up manually without use of the DOS Installer of the Toshiba Server Setup Tool.

Setup of the motherboard

Activate the BIOS Setup Utility and select “Other” for “Installed O/S” appearing in the lower part of the “Advanced” menu.

Preparation of a floppy disk

To install NetWare, you need to first copy each driver to a floppy disk, using the Toshiba Server Setup Tool.

Start the Toshiba Server Setup Tool, select “Utilities” and “Create Floppy Disks,” and copy the following drivers to floppy disks:

DOS Disk

Adaptec Ultra160 NetWare Driver