Installing Software

179

NetWare

Intel LAN NetWare Driver

AMI IDE RAID NetWare Driver

Setup of the MS-DOS environment

Installation of NetWare can be done in the three ways :

(1)Install the MS-DOS by use of the Toshiba Server Setup Tool so that the installing environment for the NetWare is automati- cally set up. After the MS-DOS is installed by the Toshiba Server Setup Tool, the environment to read the CD-ROM of NetWare is automatically set up.

See “Toshiba Server Setup Tool User's Guide” for installing the MS-DOS by the Toshiba Server Setup Tool.

(2)Create DOS disk by the “Create Floppy Disks” of the Toshiba Server Setup Tool, and manually set up the partition to activate the NetWare on the MS-DOS.

(3)Install the MS-DOS and set up the MS-DOS environment manually.

Condition of the MS-DOS environment for installing NetWare

In the case that MS-DOS is manually installed, the MS-DOS environment for installing NetWare must be set up in the following way:

(1) The extended memory has been removed.

To remove the extended memory, invalidate the lines containing the following texts in the “Config.sys” and “Autoexec.bat” by the REM statement.

In “Config.sys”

HIMEM.SYS

HIGH

EMM386.EXE

In “Autoexec.bat”

SMARTDRV.EXE