234

Following message is displayed on the front panel display and the power is automatically turned off if BIOS recovery was succeeded.

BIOS Recovery Boot succeeded.

6Following message is displayed if BIOS recovery was failed. Return to step 5 and repeat recovery process.

BIOS Recovery Boot failed.

7Disconnect the AC power cable.

8Remove the server panles, power supply unit and board for wireless card, and return the jumper switch to 1-2 short

9Replace the board for wireless card, power supply unit and server panles.

10Connect the AC power cable again and restart your server.

11Start the BIOS Setup Utility and select “Load Setup Default” from the Exit menu to execute it.

NOTE: In addition to the hardware setup switch and recovery boot switch, several jumper switchs are located on the moth- erboard. Do not disturb the settings of any switchs other than the above two, since incorrect setting may result in malfunc- tion.