66 | Installing and Removing Hardware |
Removing and replacing the server panels |
When installing an optional device to a Rack Type server, follow the instructions mentioned.
WARNING: Don't slide more than two Rack Mount Trays out of the rack at the same time. If two or more units are pulled out of the rack, the rack may become unstable and topple down.
Don't put any weight on the server that is pulled out of the rack and don't apply an excessive load to it continuously because a load may cause the rail to be damaged or the rack to be unstable. If the rack topples over, persons in close proximity may be injured.
When working on the higher section of the rack, don't put a ladder directly on the rack or the server to prevent the rail, rack and server from getting damaged or unstable. If the rack topples over, persons in close proximity may be injured.
When working on the higher section of the rack, do not use a chair with casters, because it is unstable.
When turning the claw screws of the Rack Mount Tray, remove the front panel because you may catch your fingers.
NOTE: Before sliding the server out of the rack, carefully ensure that no cables are caught in the rail preventing the server from being removed.
Slide the server gently forward until it is secured by the rail lock.
If another system or an external unit is also to be installed in the rack, be careful not to touch the eject lever of the hard disk drive or the power switch of the other system.