Getting started
Console installation (system telephone)
For installation with use of UP406 deskset in the system - set static IP
Instructions on this page are for users to enter static IP to set up the console, due to a failure in obtaining IP from the Ethernet switch or router automatically. If you have successfully obtained the IP from your Ethernet switch or router, you do not need to perform the steps below.
To set static IP when initially setting up the console:
1.If the console cannot obtain an IP address from the Ethernet switch or router after you power it up, the screen displays No IP obtained. Check network. and then displays the network setup menu.
2.Press 
or 
to scroll to Set static IP, then press MENU/SELECT.
3.The screen displays Enter static IP. Use the dialing keys to enter a specific IP.
•Press DELETE to delete a character.
•Press # to add a dot.
•Press 
/REPEAT or 
/SKIP to move the cursor to the left or right.
When entering a specific IP, make sure the IP range is not blocked by the Ethernet switch or router.
4.Press MENU/SELECT. The screen displays Subnet mask: Use the dialing keys to enter a specific subnet mask.
•Press DELETE to delete a character.
•Press # to add a dot.
•Press 
/REPEAT or 
/SKIP to move the cursor to the left or right.
5.Press MENU/SELECT. The screen displays Router/Gateway: Use the dialing keys to enter a specific gateway.
•Press DELETE to delete a character.
•Press # to add a dot.
•Press 
/REPEAT or 
/SKIP to move the cursor to the left or right.
6.Press MENU/SELECT to save. The screen displays IP obtained: XXX.XXX. XXX.X Please set an extension number to this phone.
7.Press MENU/SELECT. Press 
/REPEAT or 
/SKIP to choose the desired extension number.
8.Press MENU/SELECT to save. The screen displays Please wait... and then Starting... It takes a while for the system to finish the startup. The console enters the idle screen when the startup is done.
9.Lift the handset. If you hear a dial tone, the installation was successful.
NOTE: Make sure the static IP you entered is not occupied by other network devices. You can check the occupied IP addresses in your router menu.
16
