Getting started
Console installation
For installation with use of UP406 deskset in the system - auto set IP
If you want to use the console as a
After the console is powered up, it takes at least one minute to start up the system and the screen displays booting.... during startup. The screen displays Is
this Console going to register UP406 Desksets? ‘SELECT’: Yes ‘CANCEL’: No. Press SELECT. The screen shows Console is in system mode.
The console is set to obtain an IP address automatically by default. The screen displays Obtaining IP from DHCP server Please wait... while the console is
obtaining an IP address from the Ethernet switch or
router. After an IP address is obtained, the screen displays IP obtained: XXX.XXX.X.XXX Please set an extension number to this phone.
If the console cannot obtain IP address automatically, it displays No IP obtained. Check network. and then the Network setup menu. You may need to enter the IP address manually under the Set static IP menu. See the
instructions on the next page for details.
Is this Console
going to register UP406 Desksets?
‘SELECT’: Yes ‘CANCEL’: No
Obtaining IP from DHCP server
Please wait...
To set an extension number:
1.When the console displays IP obtained: XXX.XXX.
X.XXX Please set an extension number to this phone, press MENU/SELECT.
2.Press 
/REPEAT or 
/SKIP to choose the desired extension number.
3.Press MENU/SELECT to save.
4.The console displays Please wait... and then Starting... It takes a while for the system to finish the
startup and the console enters idle screen when the startup is done. The console is named Console by default.
5.Wait for approximately one minute for console to synchronize, then lift the handset. If you hear a dial tone, the installation was successful.
IP obtained:
XXX.XXX.X.XXX
Please set an
extension number
to this phone.
Set Ext No. 
11
15
