
16. Upgrading AFS-16 Firmware
When new, improved versions of the
Notes:
•The FTP/SFTP servers can only be started via the Text Interface.
•All other ports will remain active during the firmware upgrade procedure.
•If the upgrade includes new parameters or features not included in the previous firmware version, these new parameters will be set to their default values.
•The upgrade procedure will require approximately 15 minutes.
1.Obtain the update file. Firmware modifications can either be mailed to the customer, or downloaded from WTI. Place the upgrade CDR in your disk drive or copy the file to your hard drive.
2.Access Text Interface command mode via Serial Port, Telnet or SSH client session, using a username/password and port that permit Administrator level commands.
3.When the command prompt appears, type /UF and then press [Enter]. The
a)Start FTP/SFTP Servers Only (Do NOT default parameters): To proceed with the upgrade, while retaining
b)Start FTP/SFTP Servers & Default (Keep IP parameters & SSH Keys): To
proceed with the upgrade and default al
c)Start FTP/SFTP Servers & Default (Default ALL parameters): To proceed with the upgrade, and reset parameters to default settings, type 3 and press [Enter]. When the upgrade is complete, all parameters will be set to default values.
d)Start FTP/SFTP Servers for Slip Stream Upgrade: This option will upgrade
only the WTI Management Utility, without updating the
Note that after any of the above options is selected, the