Western Telematic AFS-16-1 manual Circuit Configuration

Basic Configuration

5.6.Circuit Configuration

The Circuit Parameters menu allows you to select parameters for the AFS-16 Circuit Modules. This allows you to assign names to the A, C, and B connectors on each Circuit Module, and also define a default A/B setting for each A/B Switch. Note that the Circuit Parameters menu is only available when you have logged into command mode using an account that permits Administrator commands. The Circuit Parameters Menu allows you to define the following parameters:

•Name (Common): Assigns a name to the Common RJ45 connector on the selected Circuit Module.

•Name (A): Assigns a name to the "A" RJ45 connector on the selected Circuit Module.

•Name (B): Assigns a name to the "B" RJ45 connector on the selected Circuit Module.

•Power Up Default: Determines how this A/B Switch will react when the "Default All Circuits" command (/DF) is invoked, or after power to the unit has been interrupted and then restored. After the default command is invoked, or power is restored, the AFS-16 will automatically set each A/B Switch to the "A" or "B" setting as specified by the Power-Up Default. (Default = "A").

Notes:

•If you have accessed command mode using an account that has Administrator or SuperUser level command access, then the Default command will be applied to all Circuit Modules.

•If you have accessed command mode using an account that has User level command access, then the Default command will only be applied to the Circuit Modules that are allowed by your account.

•The Default command is not available to ViewOnly level accounts.

5-20