I n s t a l l i n g O p t i o n s
Precautions | The DocuPrint 4512 printer options are easy to install. Installing and | |
|
| |
|
| testing any one option is likely to take 5 to 15 minutes. |
|
| Before installing or removing any printer option, take the precautionary |
|
| steps outlined below. |
|
|
|
|
| POWER OFF THE PRINTER: The printer determines which |
|
| options are installed through a |
|
| you power ON the printer. Therefore, for proper operation, you |
| Caution | must power OFF the printer before installing/removing an option, |
|
| then power it back ON after installing/removing an option. |
|
|
|
|
|
|
|
| DISCONNECT THE POWER CORD: Never remove the printer |
|
| controller board while the printer is plugged in. |
|
| To avoid the possibility of electrical shock, always disconnect the |
| Caution power cord when installing or removing ANY internal or external | |
|
| printer option. |
|
|
|
|
|
|
|
| DISCHARGE STATIC ELECTRICITY: The controller board and |
|
| internal printer options (SIMMs, PostScript board, and interface |
|
| boards) are sensitive to static electricity. Before installing or |
| Caution | removing an internal option, discharge static electricity from your |
|
| body by touching something metal, such as the metal back plate on |
any device plugged into a grounded power source. If you walk around before finishing the installation, again discharge any static electricity.
