P o s t S c r i p t B o a r d
4 |
Locate the socket on the right side of the controller board.
There is a plug on the bottom of the PostScript board that fits into the socket. There is also a plastic post fitted on the bottom of the PostScript board near the edge opposite the connector. The plastic post fits into a hole at the side of the controller board.
Line up the PostScript board plug with the controller board socket and the plastic post with its locating hole. Then push the board into place.
5 | Reinstall the controller board by sliding it carefully along the guide rails in the printer and gently |
| pushing it back into place. When it is properly seated, replace the retaining screws. |
6 | Reconnect all cables to the printer and power it ON. |
7 | Print out a Configuration Sheet (see page |
| board. |
Keep the original packaging material in case you ever need to remove
the option.
Note
A p p e n d i x B : I n s t a l l i n g O p t i o n s ❖
