I n s t a l l i n g O p t i o n s
PostScript Board
Follow these instructions for installing the PostScript board into the
printer.
The controller and PostScript boards are sensitive to static
electricity. Before installing the PostScript board, discharge static
electricity from your body by touching something metal, such as the
Caution metal back plate on any device plugged into a grounded power source. If you walk around before finishing the installation, again
discharge any static electricity.
Never remove the printer controller board while the printer is plugged in.
1 Power OFF the printer and disconnect all cables from the back of the printer. |
2 Unscrew the outside pair of retaining screws | 3 Carefully slide out the controller board. | |
holding the controller board in place. Keep the | Set the controller board down on a safe, level | |
screws in a safe place. | ||
surface. | ||
|