Xerox 4512N manual To remove a SIMM, release the spring clips

4 Select a slot for the SIMM and, holding the SIMM at an angle, line it up with the slot.

M e m o r y S I M M s

5 Push the SIMM gently but firmly down into the slot, then rotate it into position.

The SIMM should pop into place with two retaining lugs fitting into holes on either side of the SIMM and the spring clips gripping it in position.

6	To remove a SIMM, release the spring clips
	holding the SIMM in place.
7	Reinstall the controller board by sliding it
	carefully along the guide rails in the printer
	and gently pushing it back into place. When it
	is properly seated, replace the retaining
	screws.
8	Reconnect all cables to the printer and power
	it ON.
9	Print out a Configuration Sheet (see page 3-17)
	to check that the printer recognizes the

additional memory.

A p p e n d i x B : I n s t a l l i n g O p t i o n s ❖ B-5