S e t t i n g U p t h e D o c u P r i n t 4 5 1 2 / 4 5 1 2 N
Testing the Printer
To test the printer, power it ON, then print a configuration sheet using
the Control Panel.
1 Power ON the printer and observe the following sequence on the Control Panel:
The display reads Self Test.
The On Line light goes on.
The display reads Emulation Size/Size.
where Emulation is the emulation (PCL, PS2, Auto, HEX), and Size/Size is the size of paper in the upper tray/lower tray.
2 Press On Line 
.
The On Line light goes off.
The display reads Printing Menu.
3
4
5
Press Menu 
until:
The display reads Test Menu.
Press Item 
until:
The display reads Config. Sheet.
Press Enter 
.
The Data light goes on and the Configuration Sheet prints.
If the Configuration Sheet does not print, refer to Chapter 6: Troubleshooting in the DocuPrint 4512/4512N User Guide.
When the page finishes printing, the DATA light goes off.
6
7
Press On Line 
.
The On Line light goes on.
The display reads Emulation Size/Size.
If you have purchased printer options, power off the printer, unplug the power cord, and continue to “Installing Printer Options” (page 13). Otherwise, skip to “Connecting to the Host” (page 14).
12 ❖ S e t t i n g U p G u i d e
