Xerox 560, 550 manual Marks, Saddle stitch or Perfect bound, Margins, Gutter, Spine

96Chapter 11—Job parameters

Parameter	Option	Description
	Marks	Provides the following options:
		● None—Does not apply any marks on the imposition
		layout for the printed job.
		● Crop marks—Prints the lines that indicate where the
		sheet should be cropped to the trim size.
		Notes:
		● If you want to use crop marks that were incorporated
		in the DTP application, make sure that enough space
		is left around your page in the PostScript file so that
		the page prints with crop marks.
		● If your job already includes crop marks incorporated
		in the DTP application, you do not need to add crop
		marks here. If you do add crop marks, both sets of
		crop marks can be printed.
		● Fold marks—Prints the lines that indicate where the
		sheet should be folded. This option is available only
		when the imposition method is set to Saddle stitch or
		Perfect bound.
		● Crop & fold marks—Prints the lines that indicate where
		the sheet should be cropped and folded. This option is
		available only when the imposition method is set to
		Saddle stitch or Perfect bound.
		● Both Sides—Prints the marks on both sides of the page.
	Margins	Determines the space between the edge of the pages and
		the edge of the sheet on which the pages are printed.
		Notes:
		● Margin settings should suit the finishing equipment and
		requirements.
		● Confirm the binding parameters with your binder when
		planning your sheet.
	Gutter	Determines the space between pairs of pages (according to
		the trim size) on a sheet. When the pages are folded into a
		booklet, the gutter allows space for trimming.
		The value that you enter depends on the paper size and
		imposition method that you choose.
	Spine	Note: This option is available only when the imposition
		method is set to Perfect Bound.
		Determines where the signatures are joined at the center
		fold and then stitched or bound.
		The value that you enter depends on the paper size that you
		choose.