Xerox 560, 550 manual Finishing tab in the job parameters window

106 Chapter 11—Job parameters

Finishing tab in the job parameters window

Apply these settings to specify how to finish your job.

Parameter	Option	Description
Finishing	Output tray	Lists the available finisher options. This list depends on the
		modules that are installed on the printer.
		Provides the following options:
		●	OCT
		●	SCT
		●	Standard Top Tray
		●	Standard Stacker Tray
		●	Booklet Maker Tray
		●	Standard Trifold Tray
		●	Advanced Top Tray
		●	Advanced Stacker Tray
		●	Professional Top Tray
		●	Professsional Trifold Tray
		● Professional Booklet Maker Tray
	OCT (Offset catch	Provides the following option:
	tray)	Specify when to offset copies of your job. The default is set
		to 1. If you do not want to use an offset between sets, clear
		this check box.
		Note: If the page size is larger than A3 (standard or
		custom), the Offset check box is not available.
	SCT (Standard	Standard output tray with no finishing options available.
	catch tray)
	Standard Top Tray	Provides the following options:
		● Punch—The values vary according to the type of punch
			unit connected. The number of holes is 2.
		● Z-Fold half sheet
	Standard Stacker	Provides the following options:
	Tray	●	Staples—The position of the staples on the page.
		● Punch—The values vary according to the type of punch
			unit connected. The number of holes is 2.
		● Z-Fold half sheet
	Booklet Maker	Provides the following options:
	Tray	●	Booklet Staple
	Standard TriFold	Provides the following options:
	Tray	●	Tri-fold Z
		●	Tri-fold C