Xerox 550, 560 manual Advanced Top

Finishing tab in the job parameters window 107

Parameter	Option	Description
	Advanced Top	Provides the following options:
	Tray	● Offset—Offsets copies of your job
		● Punch—The values vary according to the type of punch
		unit connected. The number of holes is 2, 3, or 4.
	Advanced Stacker	Provides the following options:
	Tray	● Offset—Offsets copies of your job
		● Staples—The position of the staples on the page.
		● Punch—The values vary according to the type of punch
		unit connected. The number of holes is 2, 3, or 4.
	Professional Top	Provides the following options:
	Tray	● Offset—Offsets copies of your job
		● Punch—The values vary according to the type of punch
		unit connected. The number of holes is 2, 3, or 4.
	Professional	Provides the following options:
	Stacker Tray	● Offset—Offsets copies of your job
		● Staples—The position of the staples on the page.
		● Punch—The values vary according to the type of punch
		unit connected. The number of holes is 2, 3, or 4.
	Professional	Provides the following options:
	Booklet Maker	● Booklet Staple
	Tray
Near-line finisher	Near-line finisher	Enables you to select one of the near-line finishing devices,
		Duplo DC-645 or DSF-2000
Print order	Collated	Prints a complete copy of the job before the first page of the
		next copy is printed
	Reverse print	Sets the print order from back to front
	order
	Face up	Delivers the job face up
	Face down	Delivers the job face down
Slip sheet	Slip sheets	Prints slip sheets with your job. If a job is collated, the slip
	between copies	sheets are printed between sets. If a job is not collated, the
		slip sheets are printed between groups.
		● Tray—Enables you to select the tray on which to print
		the slip sheet
		● Frequency—Enables you to set the number of slip
		sheets that you want to print. The default is set to 1.
Image position	Same on both	Shifts the image on the sheet's second side (face down
	sides	image) according to the shift on the sheet's first side (face
		up image)
	Rear	Enables you to define the sheet's edge near the rear of the
		printer