Xerox 6050A manual System Parameter Setup Print Services on Web, 6030/6050, Qinfopen

3.8 System Parameter Setup (Print Services on Web, 6030/6050)

The system parameters listed below can be set up from Print Services on Web.

These procedures are performed on the Administrator page.

Refer to "3.4 Communication Parameter Setup (Print Services on Web, 6030/6050)" for information about setting up the [TCP/IP], [Serial], [Centro], [VPI], and [SNMP] selections in the [System Parameters] menu on the Properties tab.

The parameter nomenclature on Print Services on Web will sometimes differ from the nomenclature on the printer control panel. The printer control panel nomenclature appears in bold type in the table below.

Menu Item		Description
Priority	Determines which of the following should be set up as
	the standard for determining the priority sequence of
	job output for the same job.
	[QIN_FOPEN]	Time to start data transfer
	[QIN_FCLOSE] Time to end data transfer
Replot	Enables or disables the reprinting feature.
Print Density	Sets up the default print density level. The density
	setting is a numeric value between -99 and 99.
Paper Width for	Sets the paper width for SP. JIS/ISO A paper. The
Special A	default value is [SP A1].
(SPA PAPER	[SP. A1]	620 or 625mm
WIDTH)	[SP. A2]	435 or 440mm

84 Chapter 3 Printer Setup