Xerox 6050A manual Centronics optional, 6030/6050 Only

Centronics (optional, 6030/6050 Only)

The Centronics communication parameters are presented below.

Menu Item		Description
Ack Mode	The Ack mode is selected from [MODE0], [MODE1],
	[MODE2], [MODE3], and [MODE7].
	The default setting is [MODE0].
DMA Timeout	The timeout value for data input is entered within a range
	of 1 to 255 seconds. The default setting is [5 sec].
EOP Timeout	Determines if the EOP Timeout will be enabled [TIMEOUT]
	or disabled [NO_TIMEOUT]. If set to [TIMEOUT], a
	Timeout Value must be entered. The timeout value is
	entered within a range of 0 to 99 seconds.
	The default setting is [10 sec].
Job Separation	Sets the job separation. The default setting is [NO].
	[YES]	Starts conversion processing once the
		command that recognizes the end of the
		data is received, even if this occurs midway
		through the file.
	[NO]	Performs the spooling process on the hard
		disk until a timeout is issued.

• If a value higher than [255] is entered for the DMA Timeout value, [255] will be set as the value.

•Changes to the [Ack Mode] and [DMA Timeout] values will have no effect on operations.

66 Chapter 3 Printer Setup