Xerox 6030, 6050A manual Hpgl

PORT SETTING

TCP/IP

TCP/IP

Default Parser

Default Parser

HPGL*

IP Address

100. 000. 000. 000

IP Address

120. 000. 000. 000

IP Address

123. 123. 123. 001 *

1 Display [TCP/IP] on the selection screen, and then press the < > key.

2 Select the item that is to be set up with the

use of the <	> and < > keys, and then
press the <	> key.

[Ethernet Setting], [Default Parser], [IP Address], [Mask Value], [E-Net Address], [Dynamic Routing], and [Static Routing] will be displayed in that order.

• Additions can be made to the routing table when [Static Routing] is enabled.

•The [E-Net Address] can only be displayed, not changed.

3 Select the parameters with the use of the

<> and < > keys, and then press the <Set> key.

An asterisk [*] will be displayed on the right side of the parameters once they have been set.

Entering addresses

1.Move the cursor to the left and right with the use of the < > and < > keys.

2.Select the required value with the use of the < > and < > keys. The value will increase or decrease sequentially between 0 and 9.

3.Press the <Set> key once all values have been entered.

• To proceed to the next menu, move the cursor to the right-hand side and press the < > key.

•To return to the previous menu, move the cursor to the left-hand side and press the < > key.

70 Chapter 3 Printer Setup