Xerox 6050A, 6030 manual Procedure, TCP/IP Setup, Menu Port Setting Port Setting TCP/IP

3.2 Communication Parameter Setup

(Printer Control Panel, 6030/6050)

This section explains the procedures for setting up the communication

parameters from the printer control panel.

SNMP must be set up from Print Services on Web.

The changed parameters become valid after the machine is rebooted.

Procedure

MENU

PORT SETTING

PORT SETTING TCP/IP

1 Press the < > key with [PORT SETTING] displayed.

2 Select the interface that is to be set up with the use of the < > and < > keys, and then press the < > key.

[TCP/IP], [SERIAL], [CENTRO], and [VPI] will be displayed, in that order.

[CENTRO] and [VPI] are optional.

TCP/IP

Ethernet Setting

Ethernet Setting

AUTO*

3 Select the parameters with the use of the

<> and < > keys, and then press the <Set> key.

An asterisk [*] will be displayed on the right side of the value once it has been set up.

The changed parameters are saved to the system when the <Set> key is pressed. It is not necessary to save each change individually.

Refer to the previous section for detailed information about each of the communication parameters.

4 After setting up all of the parameters, switch

the printer power off and then on for the changes to take effect.

TCP/IP Setup

3.2 Communication Parameter Setup (Printer Control Panel, 6030/6050) 69