Xerox 6050A, 6030 manual Dhcp, RARP/BOOTP Unix

The following TCP/IP communication parameters can be set up for the 6050A using using the printer control panel on the device itself or using the Web Printer Management Tool.

Menu Item		Description
Ethernet Setting	Selects the ethernet setting/speed duplex layer.
	The default setting is [AUTO]. The 6050A is
	capable of gigabit (1000mbps full duplex)
	connections, however this is only possible when
	in [AUTO] mode and when using a CAT6 ethernet
	cable.
	[AUTO]	Automatic recognition
	[10mbps]	Half-duplex/Full-duplex
	[100mbps]	Half-duplex-Full duplex
IP Address	The IP address of the machine in the format
	XXX.XXX.XXX.XXX. The IP address can be
	changed, if necessary.
MASK Value	The sub-net mask set up on the machine in the
	format XXX.XXX.XXX.XXX. The subnet mask can
	be changed, if necessary.
Gateway	The gateway set up on the machine in the format
	XXX.XXX.XXX.XXX. The gateway can be
	changed, if necessary.
*E-Net Address	Displays the Ethernet address. The value
	displayed is unique for the hardware and cannot
	be changed.
DHCP	Dynamic Host Configuration Protocol
	automatically gives the 6050A an IP address at
	startup, providing there is a DHCP server already
	on the network.
RARP/BOOTP (UNIX)	Reverse Address Resolution Protocol (RARP) is
	used to manually obtain an IP address for the
	6050A, providing there is a RARP server already
	on the network. Bootstrap Protocol (BOOTP) is
	used to automatically obtain an IP address for the
	6050A, providing there is a BOOTP server
	already on the network.

Features marked * cannot be changed.

3.1 Communication Parameters 63