Xerox 6050A manual Serial 6030/6050 Only, Xon/Xoff, Enq-Ack, Software

Serial (6030/6050 Only)

The serial communication parameters are listed below.

The communication parameter nomenclature on the printer control panel will sometimes differ from the nomenclature on Print Services on Web. The Print Service on Web nomenclature appears in bold type in the table below.

Menu Item		Description
Default Parser	The default setting is [HP-GL].
Logical printer	Sets up a logical printer number to be use if a logical
number	printer is not defined in the print job.
Handshake	Selects the handshake method from the following choices.
	The default setting is [XON/XOFF].
	[XON/XOFF]	Handshake using the XON/XOFF protocol.
	[HARDWARE] Handshake using the hardware.
	[ENQ-ACK]	Handshake using the ENQ-ACK protocol
		(HP-GL only).
	[SOFTWARE]	Handshake using the application program
		(HP-GL only).
Baud Rate	Sets the communication speed to [300], [1200], [2400],
	[4800], [9600], or [19200].
	The default setting is [9600].
Parity	Sets the parity bit to [NONE], [EVEN], or [ODD].
	The default setting is [EVEN].
Data Bit	Sets the data bit length to [7_BITS] or [8_BITS].
	The default setting is [7_BIT].
Stop Bit	Sets the stop bit length to [1_BIT] or [2_BIT].
	The default setting is [1_BIT].
EOP Timeout	Determines whether or not to enable EOP timeout.
	The default setting is [ON] or [Enable].
Timeout Value	Sets up the EOP timeout value within a range of 1 to 255
	seconds. If a value greater than 255 is entered, the timeout
	value will be set to 255.
	The default setting is [10].
Output	Enables [YES] or disables [NO] the output response.
Response	This must be set to [YES] if the printer requires a response
	when data is transmitted from the host to the printer.
	The default setting is [NO].

64 Chapter 3 Printer Setup