ZyXEL Communications ES-3024 manual Config

		Dimension ES-3024 Ethernet Switch
		COMMAND	DESCRIPTION
		gvrp <port> <enabledisable>	Enables/disables GVRP on the
			specified port.
	svlan	cpu <vlan id>	Sets the VLAN ID of the
			management VLAN (CPU).
		setentry<name><vid><port><adctl>	Applies a static VLAN (name,
		<tagctl>	admin control tag, tag control) to
			a port.
		delentry <vid>	Deletes the specified (VID) static
			VLAN.
		active <vid>	Turns on the specified static
			VLAN.
		inactive <vid>	Turns off the specified static
			VLAN.
		list	Displays a table of static VLANs.
	vlan	list <allvidstart_vid end_vid>	Shows the specified IEEE
			802.1Q Tagged VLAN table.
	status		Shows the IEEE 802.1Q tagged
			status.
driver	config		Shows the switch’s settings.
	count	disp	Shows the switch Network Driver
			Interface Specifications (NDIS)
			level counters (CPU interface).
		clear	Clears the switch NDIS level
			counters (CPU interface).
rstp			All “sys sw rstp” commands
			relate to rapid STP configuration.
			Refer to IEEE Std 802.1w. Use
			“config save” to save your
			configuration changes.
	bridge
		enable	Enables RSTP.
		disable	Disables RSTP.
		priority <priority>	Sets the system priority.
		maxage <max age>	Sets the max age timer
		hellotime <hello time>	Sets the hello timer.
		forwarddelat <forward delay time>	Sets the forward delay time
		version <stp:0rstp:2>	Displays/enables the STP mode;
			STP or RSTP. RSTP is the
			default used when configuring
			STP via web configurator.
	port
		enable <port_no>	Enables RSTP on this port.
		disable <port_no>	Disables RSTP on this port.

Commands Introduction 21-9