ZyXEL Communications ES-3024 manual VLAN1Q Port Status Command

<port>

<VID>

Dimension ES-3024 Ethernet Switch

ras> sys sw gvrp disable

This command turns off GVRP so that the switch does not propagate VLAN information to other switches.

23.4.6VLAN1Q Port Status Command

Syntax:

ras> sys sw vlan1q port status <port>

This command shows information about the specified port’s VLAN settings.

The following example shows the settings for port 1.

ras> sys sw vlan1q port status 1 Port 2 VLAN Setup :

Default VLAN ID = 1

VLAN Acceptable Type = Tagged Only GVRP = Enable

Figure 23-7 VLAN1Q Port Status Command Example

23.4.7VLAN1Q Port Default VID Command

Syntax:

ras> sys sw vlan1q port defaultVID <port> <VID>

where

= A port number

= The VLAN ID. Valid parameter range = [1 – 4094].

This command sets a default VLAN ID for all untagged packets that come in through the specified port. The following example sets the default VID of port 1 to 2000.

ras> sys sw vlan1q port defaultVID 1 2000

Figure 23-8 VLAN1Q Port Default VID Command Example

23.4.8VLAN1Q Port Accept Command

Syntax:

ras> sys sw vlan1q port accept <port> <alltagged>

where
<port>	=	A port number
<alltagged> =		Specifies all Ethernet frames (tagged and untagged) or only tagged
		E h	f
IEEE 802.1Q Tagged VLAN			23-5