Dimension
1.ras> sys sw vlan1q svlan cpu 3
2.ras> sys sw vlan1q svlan delentry 1
Figure 23-3 Deleting Default VLAN Example
23.4IEEE VLAN1Q Tagged VLAN Configuration Commands
These sw (switch) commands allow you to configure and monitor the IEEE 802.1Q Tagged VLAN.
23.4.1GARP Status Command
Syntax:
ras> sys sw garp status
This command shows the switch’s GARP timer settings, including the join, leave and leave all timers. An example is shown next.
ras> sys sw garp status GARP Timer Status :
Join Timer = 200 msec Leave Timer = 600 msec Leave All Timer = 10000 msec
Figure 23-4 GARP Status Command Example
23.4.2GARP Timer Command
Syntax:
ras> sys sw garp timer timer <join timer(ms)> <leave timer(ms)> <leave all timer<ms>
where
<join timer (ms)> | = | This sets the duration of the Join Period timer for GVRP in |
|
| milliseconds. Each port has a Join Period timer. The allowed |
|
| Join Time range is between 100 and 32767 milliseconds; the |
|
| default is 200 milliseconds. |
<leave timer(ms)> | = | This sets the duration of the Leave Period timer for GVRP in |
|
| milliseconds. Each port has a single Leave Period timer. Leave |
|
| Time must be two times larger than Join Timer; the default is |
|
| 600 milliseconds. |
IEEE 802.1Q Tagged VLAN |
