Dimension
Table 21-1 command summary
|
| COMMAND | DESCRIPTION |
|
|
|
|
|
| brief | Displays a brief listing of packet |
|
|
| contents. |
| version |
| Displays the RAS code and driver |
|
|
| versions. |
| view | view <filename> | Displays the specified text file. |
| wdog |
|
|
|
| switch [onoff] | Turns the watchdog firmware |
|
|
| protection feature on or off. |
|
| cnt [value] | Sets |
|
|
| current watchdog count (in 1.6 sec |
|
|
| units). |
|
|
|
|
| monitor | status | Displays the status of the |
|
|
| hardware monitor. |
|
| show | Displays the hardware monitor’s |
|
|
| statistics. |
|
| vlimit <idx> <high> <low> | Sets the maximum (<high>) or |
|
|
| minimum (<low>) voltage at the |
|
|
| specified point (<idx>). |
|
| tlimit <idx> <limit> | Sets the maximum (<limit>) |
|
|
| temperature at the specified point |
|
|
| (<idx>). |
|
|
|
|
|
| flimit <bank> <idx> <limit> | Sets the maximum (<limit>) fan |
|
|
| revs per minute (RPM) at the |
|
|
| specified fan (<idx>) in the |
|
|
| specified bank (<bank>). A “bank” |
|
|
| delineates a set of fans. |
|
| fanmask <bank> [<mask>] | Sets the fan detection mask in the |
|
|
| specified bank (<bank>). Use the |
|
|
| mask to disable monitoring of a |
|
|
| fan. |
|
| vclear | Clears the voltage statistics. |
|
| tclear | Clears the temperature statistics. |
|
| fclear | Clears the fan statistics. |
|
| clear | Clears the hardware monitor |
|
|
| statistics. |
|
| enable [<on/off>] | Enables or disables the hardware |
|
|
| monitor. |
|
| test | Tests the hardware monitor chip. |
| ixe2424 | lbt intlbt <portAll> [count] | ixe2424 refers to the switch chip. |
|
|
| Performs an internal loop back test |
|
|
| on a specified port or all ports. |
|
|
|
|
|
| lbt extlbt <portAll> [count] | Performs an external loop back |
|
|
| test on a specified port or all ports. |
Commands Introduction |
