ZyXEL Communications n/a System Commands, 19.1 Command Summary

19

System Commands

Use these commands to configure system related settings on the ZyXEL Device.

19.1 Command Summary

The following section lists the commands for this feature.

The following table describes input values for some of the sys commands. Other values are discussed with the corresponding commands.

Table 43 sys Command Input Values

LABEL	DESCRIPTION
community	The SNMP community (or password).
compare-type	Describes the result of a comparison of a packet field with that specified in a rule.
	There are four possible values:
	0:None -Do not compare the packet field with that specified in the rule.
	1:Equal -The packet field value is the same as that specified in the rule.
	2:NotEqual -The packet field value is not the same as that specified in the
	rule.
	3:Less -The packet field value is less than that specified in the rule.
	4:Greater -The packet field value is greater than that specified in the rule.
filter-action	Sets the action when a filter set is checking a packet. The options are:
	forward: This forwards the packet to its destination.
	drop: This drops the packet.
	checknext: Sets the filter to check the next rule. Use this option if the packet
	must be checked against more than one rule.
groupid	The number of a tripleplay port-interface group mapping policy.
interface	An interface on the ZyXEL Device. These are usually as follows:
	enif0: LAN
	enif1: WAN
	wanif0: PPPoE
	If the device supports WLAN then:
	enif1: WLAN
	enif2: WAN
mail-address	An e-mail address
password	<32 ASCII characters
ports	A list of port numbers.
protocol#	0 = ICMP, 6 = TCP, 17 = UDP

	117
DSL & IAD CLI Reference Guide