Chapter 20 VoIP Commands
20.5.1 VoIP Speed Dial Command Examples
This example configures a speed dial entry for a
ras> voice config phbook index 1 ras> voice config phbook active 1 1 PhoneBook active on
ras> voice config phbook orignum 1 12345
ras> voice config phbook forcesipuri 1 172.16.1.201 ras> voice config phbook type 1 1
ras> voice config phbook speednum 1 #01 ras> voice config phbook name 1 Andre ras> voice config phbook save 1
ras> voice config phbook display 1
================================================
origNumber: 12345
forceSipURI: 172.16.1.201
speedNumber: #01
name: Andre
flags: active
type:
20.6 VoIP Common Settings Commands
Use these commands to configure IVR (Interactive Voice Response), PSTN fallback and other common settings on the ZyXEL Device.
Table 53 Common Settings Command Summary
COMMAND | DESCRIPTION |
voice config common index <index> | Specifies the common settings entry index for |
| configuration. |
voice config common ivrsyspermit <index> | Enables (1) or disables (0) changing the IVR settings. |
<01> |
|
voice config common specialFlag <index> | This is a command which tests SIP communication. It is |
<special flagh:for help> | a |
| Bit 0 specifies when to send RTP traffic. If bit 0 is set to 0, |
| then send RTP after sending 200OK message, otherwise |
| send RTP after receiving ACK message. |
| Bit 1 specifies when to send 200OK message. If set to 0, |
| then send 200OK message when receive NOTIFY |
| message, otherwise follow RFC3265. |
|
|
voice config common ivrcodec <index> | Sets the voice codecs to be used by the ZyXEL Device. |
<codec> | Type one of the following: |
| • 0 to enable G.711 µ |
| • 4 to enable G.723 |
| • 8 to enable G.711 A |
| • 18 to enable G.729 - This setting is recommended. |
| • 97 to enable G.726 24K |
| • 98 to enable G.726 32K |
|
|
| 141 |
DSL & IAD CLI Reference Guide | |
|
|