9

CNM Agent Commands

Use these commands to configure CNM agent settings on the ZyXEL Device.

"At the time of writing, only P-662 series has the commands described in this chapter.

9.1Command Summary

The following section lists the commands for this feature.

Table 22 CNM Commands

COMMAND

DESCRIPTION

cnm active [0:disable1:enable]

Enables or disables the CNM service on the ZyXEL

 

Device. After enabled, the ZyXEL Device communicates

 

with the CNM server through the ZyXEL Device’s WAN.

 

 

cnm sgid [id]

Displays the unique ID received from the CNM server

 

after the ZyXEL Device registered suceessfully.

cnm managerIp

Displays or sets the CNM server's IP address.

cnm debug [0:disable1:enable]

Controls whether the debugging information is displayed

 

on the console. You must use 115200 bps for the baud

 

rate to display the debugging message.

 

 

cnm reset

Resets the CNM service to the initial status on the ZyXEL

 

Device. The ZyXEL Device will register itself to the CNM

 

server again if the service is enabled.

 

 

cnm encrymode

Displays or sets the encryption mode.

[0:none1:des2:3des]

 

cnm encrykey [key]

Displays or sets the encryption key.

 

The encryption key is 8 characters when the encryption

 

mode is set to “DES”.

 

The encryption key is 24 characters when the encryption

 

mode is set to “3DES”.

 

 

cnm keepalive <10-655>

Sets how often (in seconds) the ZyXEL Device sends a

 

keepalive packet to inform the CNM server of its

 

existence.

 

 

 

57

DSL & IAD CLI Reference Guide