ZyXEL Communications n/a 21.8.1 wan tr069 Examples

Chapter 21 WAN Commands

Table 68 wan zeroCfg Commands (continued)

COMMAND	DESCRIPTION
wan zeroCfg flag <0~7>	Use this command to configure the zero
	configuration settings.
	This command allows you to configure three
	parameters:
	zeroCfh: zero configuration.
	auto-hunt: VPI/VCI auto-hunting.
	password: user password.
	This is a binary data field with three bits, so you can
	control the three parameters by entering decimal
	(base-10) numbers that correspond to 3-bit binary
	numbers. The first bit controls zeroCfh, the second
	bit controls auto-hunt, and the third bit controls
	password.
	For the auto-huntand password parameters, a
	binary value of 1 turns the parameter on, and a
	binary value of 0 turns it off.
	However, for the zeroCfh parameter, a binary
	value of 0 turns the feature on, and a binary value of
	1 turns it off.
	Thus, if you enter “6” (110 in binary), the following
	displays:
	=====================================
	zeroCfgFlag = 6
	-- zero-configure is enable now
	-- had checked auto-hunt
	-- check password of PPPoE/PPPoA is
	correct
	no page need to redirect ..
	Auto hunt is enable
	Debug mode is disable
wan zeroCfg status	Displays current zero configuration information.

21.8.1 wan tr069 Examples

The following example:

•Turns zero configuration on.

•Turns zero configuration debugging on.

•Sets the zero configuration flag to turn zero configuration on, and auto-hunting and user password off.

172
	DSL & IAD CLI Reference Guide